Bond Aluminum Reliably
Stops aluminum bond failures traced to oxide layer drift, contamination, or uneven treatment, screened before the adhesive is applied rather than found after scrap or rework.
Method guide
CONTENT HUB
Bonding and Adhesion Reliability
Most bond failures start at the surface: oil, release agent, an oxide layer that drifted, or a plasma or flame treatment that faded. A water contact angle or surface energy check between surface preparation and bonding catches these parts before adhesive and cure time are spent. Used in automotive, aerospace, packaging and medical device assembly.
Use cases showing how a pre bond wetting check catches contamination, oxide drift, and uneven surface treatment before adhesive goes on, covering metals, plastics, and plasma treated surfaces.
Bond Polypropylene (PP) Reliably
A pre-bond wetting gate for polypropylene and other low surface energy plastics, catching failures from low surface energy, uneven treatment, or hydrophobic recovery before adhesive goes on.
Relevant to
Method guide
Flame Treatment for Adhesion
Confirms flame treatment actually took, in every zone, and hasn't faded before painting, printing or bonding.
Relevant to
Method guide
Plasma Treatment for Adhesion
Confirms plasma or corona surface activation actually took, and hasn't decayed, before an adhesive bond is committed, catching under-treatment or treatment aging before it becomes a failed joint.
Relevant to
Method guide
Prevent Adhesive Failure Before Bonding
A numeric wetting check between surface preparation and bonding, catching contaminated or untreated parts before adhesive and cure time are spent.
Method guide